Operating System: Windows XP Professional (5.1, Build 2600) Service Pack 1 (2600.xpsp2.030422-1633)
Language: English (Regional Setting: English)
System Manufacturer: Micro-Star Inc.
System Model: MS-6566E
BIOS: Version 1.00
Processor: Intel(R) Pentium(R) 4 CPU 2.80GHz
Memory: 512MB RAM
Page File: 186MB used, 1063MB available
Windows Dir: C:\WINDOWS
DirectX Version: DirectX 9.0b (4.09.0000.0902)
DX Setup Parameters: Not found
DxDiag Version: 5.03.0001.0902 32bit Unicode
---------------
Display Devices
---------------
Card name: NVIDIA GeForce3 Ti 200
Manufacturer: NVIDIA
Chip type: GeForce3 Ti 200
DAC type: Integrated RAMDAC
Device Key: Enum\PCI\VEN_10DE&DEV_0201&SUBSYS_88511462&REV_A3
Display Memory: 64.0 MB
Current Mode: 1024 x 768 (32 bit) (72Hz)
Monitor: SyncMaster 151S/155S/150S/151V, SyncMaster Magic CX151S(M)
Monitor Max Res: 1024,768
Driver Name: nv4_disp.dll
Driver Version: 6.14.0010.4403 (English)
DDI Version: 9 (or higher)
Driver Attributes: Final Retail
On first startup, it locked when I tried to redo the video setup.
Then rebooted, started again, everything worked fine (aint touching video setup again).
Moving to ship caused program to crash.
No issues with flight, besides those mentioned by skuzzy.
fps 50-75 at all times. At first it was in the 30s but after 1 min it was up where it should be. Even when flying close to the ground or shooting at the droves.
Was able to change stick settings and yadda yadda in flight with no crash.
Bouncing clipboard in hangar though.
erg out.
