Author Topic: Rivet size (Read 932 times)

United · « **on:** June 24, 2004, 02:31:25 AM »

When you skinners make rivets on the skins, how big are they? 1 pixel...? I saw Wotan's post in Frenchy's jug thread and it looks to me that they are only 1 pixel big. How big do they need to be for a 1024x1024 skin?

Wotan · « **Reply #1 on:** June 24, 2004, 03:01:37 AM »

I do 1 pixel

Sequence:

1 pixel; 3 (1 pixel) spaces; 1 pixel etc...

Sikboy · « **Reply #2 on:** June 24, 2004, 09:02:12 AM »

The Yak-9s have two different sized rivets. For the big ones along the main panel lines I use a rounded 4 pixel dot with a hollow center at 2048x2048 (but I'm unhappy with how it reduces, so I'll probably try something else). And the smaller rivets are just a single pixel. Right now I'm spacing every 5 pixels, but even that's up in the air. I'm starting all over again for the 3rd time so I'll probably try closer spacing for the small rivets.

-Sik

Kev367th · « **Reply #3 on:** June 24, 2004, 12:41:11 PM »

Thought I read somewhere that 1 rivet (pixel) 2 spaces 1 rivet(pixel) closely approxiamates real spacings.

Citabria · « **Reply #4 on:** June 24, 2004, 01:57:46 PM »

depends on skin size.

htc plane skins are all different scales so no one rivet size will be accurate if you want exact scale.

real rivets especially flush rivets are quite small and barely visable.

Citabria · « **Reply #5 on:** June 24, 2004, 01:57:56 PM »

depends on skin size.

htc plane skins are all different scales so no one rivet size will be accurate if you want exact scale.

real rivets especially flush rivets are quite small and barely visable.

MachNix · « **Reply #6 on:** June 24, 2004, 02:04:29 PM »

As Citabria said, be mindful of the size of the actual aircraft and the skin. For the P-51D, the actual aircraft is about 23 feet long. The skin has the fuselage split into forward and aft sections. The forward section represents about 17.25 feet and spans the full width of the skin (1024px). The pixel density is then about 60px per foot. At that density, a quarter inch rivet head is about 1.25 pixels. I have been simulating this by using 4px arrange like this:
Grey | White
Black | Grey
and then making them somewhat transparent.

Take a look at this link to see some actual rivets:
http://www.littlefriends.co.uk/gallery-pu.jsp?index=5&Group=352

SlapShot · « **Reply #7 on:** June 24, 2004, 02:53:10 PM »

Sik ... those larger ones actually look like flat-head screws to gain access to that area, rather then large rivets.