Author Topic: M.S Force feed Back? (Read 683 times)

Dogbod · « **on:** December 26, 2000, 02:23:00 AM »

Hi guys is there any way to eliminate the
rudder control on the handle,I would like
to use my pedals

SKurj · « **Reply #1 on:** December 26, 2000, 09:59:00 AM »

Dogbod, I use pedals with my Sw prec pro.

AH detects all available devices and lists them in the joystick selection screen. Just assign rudder controls to the pedals instead of the stick.

AKskurj

Dogbod · « **Reply #2 on:** December 26, 2000, 11:47:00 AM »

SKurj,when I go into joystick selection
It shows me the MS forcefeed back stick but
I'm not sure how to cancel the rudders on the
handle and put them on my pedals.Any suggestions would be helpful

K-KEN · « **Reply #3 on:** December 28, 2000, 09:24:00 PM »

I have an older version, but if you go into Control Panel (Windows), and uncheck the RUDDER box, that might help ya. (might be the "Calibration" thingy on yours)

Quote

Originally posted by Dogbod:
SKurj,when I go into joystick selection
It shows me the MS forcefeed back stick but
I'm not sure how to cancel the rudders on the
handle and put them on my pedals.Any suggestions would be helpful

K-KEN

http://www.cutthroats.com/

Dogbod · « **Reply #4 on:** December 29, 2000, 01:04:00 AM »

Thx guys fixed it

bowser · « **Reply #5 on:** December 30, 2000, 10:49:00 AM »

How were able to fix it Dogbod? I had to use a special adapter, was wondering if there were other ways to use MS FF Pro with seperate rudder pedals.

bowser

Dogbod · « **Reply #6 on:** December 30, 2000, 10:11:00 PM »

Hey Bowser,you really want to know??????
I got rid of that stick

I went back to my old one for now,mainly
because AH doesn't support forcefeed back
I'll try again when they do,then I be asking
you how to fix it

sorry I could not help you

Dogbod

Starbird · « **Reply #7 on:** January 01, 2001, 12:58:00 AM »

I have a ms sidewinder FF, and can use it fine with my usb ch pedals.

Just go into the joystick area (where you assign joystick axis').

Click on select joystick

Click on rudder in the left most box (the one that says ah control)

Select your rudder pedals in the middle box (in my case CH pro pedals usb)

Then select the axis for the rudder (in my case X-axis)

If you have toe brakes, you can set them up hte same way, Y being left brake, Z being right brake (I think).

If you can't pick your rudders in the middle box (labeled joystick), I'm not sure how you set them up.

Also, make sure that the twisty motion on your sidewinder isn't assigned to anythign (unless you do want to use it for something).

If anyone would like some screenshots of these steps, let me know and I'll post some.