Author Topic: New, need help with x45 throttle+CH Fstick (Read 272 times)

Zellak · « **on:** December 27, 2004, 08:00:22 PM »

Hello, I'm from WW2OL and wanting to give this a try. I use an x45 throttle combined with the CH Fighterstick. How do I set these up in game? I finally got my x45 rudder and throttle going (rotary also) along with the stick of the ch. However when I map buttons they don't seem to work... not even the engine. Is there something I'm over looking?

thebest1 · « **Reply #1 on:** December 27, 2004, 08:03:06 PM »

in set up, joystick, settings, select joystick. set the inputs for the throttl to "throttle" and so on.

Zellak · « **Reply #2 on:** December 27, 2004, 08:06:15 PM »

ok and what of the buttons under that? do I have to select the bottons in stick map and then match them up in stick select? Also How do I get the x45 throttle to activate in stick map over the ch fighterstick?

Zellak · « **Reply #3 on:** December 27, 2004, 09:26:15 PM »

heh now im really getting frustrated.. I can only use buttons on the throttle or the stick... NOT both of them.. so if I set to throttle only throttle works and if I set to stick only stick works....

JB73 · « **Reply #4 on:** December 28, 2004, 08:44:18 AM »

hmmm i use the exact same setup with no problems.

are yuo using the programming software for both the CH and the x45?

i am, and all is well. all buttons programmed as key strokes.

try setting those up, then deletingthe stick.cfg file in the AH game folder.

enter the game fresh it will make a new file, and you should be able to assign the axis fine then.