Author Topic: Modelling Question  (Read 325 times)

Offline frank3

  • Plutonium Member
  • *******
  • Posts: 9352
Modelling Question
« on: April 04, 2005, 07:54:01 AM »
I'm about to start making a Tamiya 1/48 Fw-190D-9 with Verlinden engine/cannon set.

1st question:

I've heard of oil-painting or something to get shades like the pictures below.
How do I do that, what do I use?

2nd question:

What do I use for cutting out parts of the kit? I've experienced a knive was too...crude for the delicate job.



Offline Shane

  • Platinum Member
  • ******
  • Posts: 7983
Modelling Question
« Reply #1 on: April 04, 2005, 12:42:08 PM »
1.  washes... and/or drybrushing.

http://www.aircraftresourcecenter.com/TnT_Archives/Washes-weathering.htm

http://www.aircraftresourcecenter.com/TnT_Archives/Drybrushing.htm


2. use some wire cutter-type thing... snip carefully then sand down any little nub remaining.

http://www.ares-server.com/Ares/Ares.asp?MerchantID=RET01229&Action=Catalog&Type=Product&ID=80974

third on top right side, blunt nosed clippers work great, as well as some regualr, first top left.

2a.  unless you meant opening up panels and stuff?  small, thin razor saw.  but whatever you use, it's all about taking your time and being careful.

http://www.aircraftresourcecenter.com/tnt1/001-100/TNT018_X-acto_Saw/TnT018.htm

http://www.ares-server.com/Ares/Ares.asp?MerchantID=RET01229&Action=Catalog&Type=Product&ID=82980

or a jeweler's saw..

https://secure.2spi.com/catalog/tools/smtol17.shtml
« Last Edit: April 04, 2005, 12:50:51 PM by Shane »
Surrounded by suck and underwhelmed with mediocrity.
I'm always right, it just takes some poepl longer to come to that realization than others.
I'm not perfect, but I am closer to it than you are.
"...vox populi, vox dei..."  ~Alcuin ca. 798
Truth doesn't need exaggeration.

Offline StarOfAfrica2

  • Platinum Member
  • ******
  • Posts: 5162
      • http://www.vf-17.org
Modelling Question
« Reply #2 on: April 04, 2005, 01:09:08 PM »
Frank, I'm nowhere near the guru that some of these guys are on building models, but one trick I use for cutting out those little parts is to take a Xacto knife and heat the blade with a lighter, then just touch the edge to the connectors.  Goes right thru with just a little pressure.

Offline frank3

  • Plutonium Member
  • *******
  • Posts: 9352
Modelling Question
« Reply #3 on: April 04, 2005, 01:49:19 PM »
Thanks Shane, these were exactly the pages I've been looking for!

StarofAfrica, that might just work! I'll get right to it this week! Thanks guys, you really help the newb I am out here :)
« Last Edit: April 04, 2005, 01:51:49 PM by frank3 »