Author Topic: Mouse ball replacement  (Read 1694 times)

Offline Ripsnort

  • Radioactive Member
  • *******
  • Posts: 27251
Mouse ball replacement
« on: May 11, 2000, 10:23:00 AM »
Mouse Ball Replacement Memo

I don't know how they wrote this with a straight face. This apparently was a real memo sent at a computer company to its employees in all seriousness...

This memo is from an unnamed computer company. It went to all field engineers about a computer peripheral problem. The author of this memo was quite serious. The engineers rolled on the floor.

Mouse balls are now available as FRU (Field Replacement Unit).

Therefore, if a mouse fails to operate or should it perform erratically, it may need a ball replacement. Because of the delicate nature of this procedure, replacement of mouse balls should only be attempted by properly trained personnel.

Before proceeding, determine the type of mouse balls by examining the underside of the mouse. Domestic balls will be larger and harder than foreign balls. Ball removal procedures differ depending upon the manufacturer of the mouse.

Foreign balls can be replaced using the pop-off method.
Domestic balls are replaced by using the twist-off method.

Mouse balls are not usually static sensitive. However, excessive handling can result in sudden discharge. Upon completion  of
ball replacement, the mouse may be used immediately.

It is recommended that each replacer have a pair of spare balls for maintaining optimum customer satisfaction. Any customer missing his balls should suspect local personnel of removing these necessary items."



------------------
Ripsnort(-rip1-)
I./JG2~Richthofen~
=CO=Panzer Group Afrika-15th Panzer division
JG2 Communications Officer
Aces High Training Corps

CLICK>> JG2 "Richthofen"
CLICK>> 15th Panzer Division

Too often, we lose sight of life's simple pleasures.  Remember, when
someone annoys you it takes 42 muscles in your face to frown, BUT, it
only takes 4 muscles to extend your arm, grasp the joystick button,
and shoot the sucker down!