Testors 426 hemi help

[nirvana]

I bought the model fisguring it would be a neat project.  After the bearings were just about stripped due to the other bearings coming undone I decided to glue them in.  Next I went to attach the cam gear to the crank gear and the pieces don't line up, they are off by about 5 MM, not much but enough so that they don't even touch.  The cam gear is too far back, or the crank gear is too far forward.  Either way I haven't progressed very far in the 3 hours i've worked on it.  Any help is much appreciated.

[Roscoroo]

if the crank gear slides on the shaft if suggest filing down the rear of it until it lines up with the cam gear .

if not you'll need to shim the cam gear forward to match the crank .