Author Topic: CH pro pedals and yoke (Read 344 times)

sd8468 · « **on:** November 03, 2007, 07:21:29 PM »

The pedals and yoke are way to sensitive is there a way to put down the sensitivity

thanks for helping

CrazyOWl · « **Reply #1 on:** November 03, 2007, 11:13:34 PM »

Try to calibrate them. I dont have the yoke but have the CH rudders. One time i mut a rudder just a little bit each one not full then hit csalibrate. It work for me also try to fix the ailerons rudders all the movement in advance. If you need a picture of how it look let me know and Ill send them.

By the way hows that CH yoke. Iam thinking in getting one but dont know if the CH one ot the saitek one. They say CH looks kind of weir cause of ythe plastic. but the Saitek yoke the say have some phantom buttons proble. Let me know if you know anything or how is it the oone you have.

JB73 · « **Reply #2 on:** November 03, 2007, 11:28:05 PM »

in AH there is also deadband and dampening available in the stick settings. that may help a bit.

also in the advanced stick scaling you can adjust the stick in bands with quite fine detail.

hope that helps.

wrag · « **Reply #3 on:** November 04, 2007, 05:47:54 AM »

Suggest you use the CH Control Manager software to calibrate!

Works GREAT! Better then just using regular windows to cal.......

And what JB73 said, try using the scaling feature, find it by clicking the advance box in the controller portion of AH map Controls section.

Hope that helps

sd8468 · « **Reply #4 on:** November 04, 2007, 07:26:48 AM »

just a question what is deadband

JB73 · « **Reply #5 on:** November 04, 2007, 11:27:24 AM »

Quote

Originally posted by sd8468
just a question what is deadband

in AH the deadband setting controls how much "dead" area in the center of the stick there is.

say your stick has a 2 inch throw left and 2 in right. the higher deadband setting the more space in the middle of the stick your input does not count.

you could set it so you can move the stick an entire ince left or right and it will do nothing.

the dampening setting controls how much input there is with movement.

the higher dampening setting the less input for minute movements. say moving your stick 1 inch in AH counts as 45 degrees of deflection, a higher dampening setting could make 1 inch stick movement could count as 20 degrees of deflection in AH.

I really dumbed this explanation down just to give you a simple quick understanding, but that's the gist of it. hope that helps.

sd8468 · « **Reply #6 on:** November 04, 2007, 12:04:28 PM »

ok thx i got