« previous next »
Pages: [1]   Go Down

Author Topic: Re: Dual throttle home build- attn Homeboy et al  (Read 181 times)

Offline Delirium

  • Platinum Member
  • ******
  • Posts: 7276
Re: Dual throttle home build- attn Homeboy et al
« on: May 20, 2008, 06:36:33 PM »
Yes, the wire I bought had the connector already attached.. from what I remember, it is green, black, red and only fits in one port on the main board.

I've completely seperated the board from the wiring, epoxy and joystick cables. I've had no success getting it to operate once again... I didn't get a chance to call CH today but I will do so tomorrow.
Logged
Delirium
80th "Headhunters"
Retired AH Trainer (but still teach the P38 selectively)

I found an air leak in my inflatable sheep and plugged the hole! Honest!

Offline HomeBoy

  • Nickel Member
  • ***
  • Posts: 666
      • HomeBoy's Inventions
Re: Dual throttle home build- attn Homeboy et al
« Reply #1 on: May 20, 2008, 09:49:34 PM »
Well darn.  I felt sure it was the USB cable.  I really don't think the putty did any harm but I sure am scratching my head over what could have caused such a thing.  I have been pretty rough with those things and they seem almost indestructible (relatively speaking).  This really is a mystery.
« Last Edit: May 20, 2008, 09:57:14 PM by HomeBoy »
Logged
The Hay Street Boys
Pages: [1]   Go Up
« previous next »