« previous next »
Pages: [1]   Go Down

Author Topic: X52 axes  (Read 312 times)

Offline Flifast

  • Copper Member
  • **
  • Posts: 311
      • Claim Jumpers
X52 axes
« on: May 18, 2009, 10:39:24 PM »
How can I get the x y axes centered.  I do the calibration...stays where it is at everytime and the X52 profile control panel show it off to the right also but I can't move it.  It's a new X52 after the last one wore out.  Fli

Logged

Offline bustr

  • Plutonium Member
  • *******
  • Posts: 12436
Re: X52 axes
« Reply #1 on: May 19, 2009, 03:15:15 AM »
Try reinstalling the Saitek drivers. If this is an X52 Pro and you simply plugged it in out of the box letting the old install pick it up, reinstall drivers.
Logged
bustr - POTW 1st Wing


This is like the old joke that voters are harsher to their beer brewer if he has an outage, than their politicians after raising their taxes. Death and taxes are certain but, fun and sex is only now.

Offline Flifast

  • Copper Member
  • **
  • Posts: 311
      • Claim Jumpers
Re: X52 axes
« Reply #2 on: May 19, 2009, 08:50:10 AM »
I turned on the computer checked this site and went to the X52 control panel and everything was centered...these computer people sure know how the rest of us work.  It's the same for the Airbus 320, shut it down and reboot and i'll clear all your problems!  TY Fli
Logged
Pages: [1]   Go Up
« previous next »