I now use CH USB rudders, but when I used to use a set of analog rudder pedals with my Saitek all I did was set up another stick in the Windows Joystick area with rudder pedals checked and calibrated. Then when I went to Aces High joystick setup area I just chose the rudder for the rudder axis and Saitek for the other controls.
Now if you have trouble choosing the right type of stick (which you ignore) to set up that analog set of pedals in Windows, then just get an old analog stick and plug both the pedals and stick into the analog joystick port. Set em up by checking pedals and calibrate. Then put the old stick on the floor out of the way.
I never have used any special set of drivers, other than the standard install drivers, for either my analog/Saitek setup or even my USB pedals/Saitek setup. You don't need them in Aces High. You may need them for the USB pedals only with other flight sims.
Ranger Bob
[This message has been edited by RangerBob (edited 03-08-2001).]
