Author Topic: question about 4 in 1 drivers (Read 705 times)

-ammo- · « **on:** November 01, 2001, 11:54:00 AM »

I should recieve my hardware new MB, CPU, HD, etc.. and want to get started building and installing. I was going to D/L the 4 in 1 drivers to have ( I am using Win2K SP2 for an OS) but the page has many versions to D/L. Do I just D/L the latest version?

new system spec's--

aknimitz · « **Reply #1 on:** November 01, 2001, 12:01:00 PM »

Thats what I did ammo and have had zero problems. I think each is just a minor improvement on the former. Piece of cake to install too

Good luck!

Nim/Larry

bloom25 · « **Reply #2 on:** November 01, 2001, 03:45:00 PM »

I think the newest is the 4.35s, I'd just get them.

-ammo- · « **Reply #3 on:** November 01, 2001, 05:41:00 PM »

nother question, looking at the MB manual, it states that teh default jumper setting for the CPU Host clock select is 100MHz, but I can set it at 133MHz. Which shopuld I use if I am using PC2100 RAM?

Camel · « **Reply #4 on:** November 01, 2001, 05:51:00 PM »

Sancho · « **Reply #5 on:** November 01, 2001, 08:20:00 PM »

Your new CPU is a Athlon XP 1600 right? Use 133 MHz for bus speed with a 10.5x multiplier. Read this down where it explains PC2100--use 133MHz.

-ammo- · « **Reply #6 on:** November 01, 2001, 08:27:00 PM »

TY sir

So I just set the jumper in the 133 position and no other action by me is needed?

Sancho · « **Reply #7 on:** November 01, 2001, 08:49:00 PM »

dunno man, you check the manual? I was going to look and help ya out, but epox is hosting their website on a 56k line or something and the manual won't be done downloading until sometime tomorrow.