Author Topic: Lead computing gunsite problem?  (Read 630 times)

Offline TDeacon

  • Silver Member
  • ****
  • Posts: 1553
Lead computing gunsite problem?
« on: November 14, 2010, 08:36:19 PM »
Somehow, I have caused my lead-computing gunsite to show 2 (two) aimpoints.  I thought it was only supposed to show one.  Any thoughts on this?

Thanks in advance,
MH

Offline fuzeman

  • Aces High CM Staff
  • Plutonium Member
  • *******
  • Posts: 8971
Re: Lead computing gunsite problem?
« Reply #1 on: November 14, 2010, 08:51:55 PM »
It is supposed to show two as you have a primary and secondary gun.
Far too many, if not most, people on this Board post just to say something opposed to posting when they have something to say.

"Masters of the Air" Scenario - JG54

Offline TDeacon

  • Silver Member
  • ****
  • Posts: 1553
Re: Lead computing gunsite problem?
« Reply #2 on: November 14, 2010, 10:32:58 PM »
On the P51, it only shows one.  I suppose that is because both primary and secondary have the same ballistics?

Offline Ghastly

  • Silver Member
  • ****
  • Posts: 1756
Re: Lead computing gunsite problem?
« Reply #3 on: November 14, 2010, 10:48:09 PM »
It will show two points if you have differing convergence for your guns, and I believe it shows 2 points when you have rounds with differing muzzle velocities - most noticeably when you are pulling G's especially (i.e, bb's and cannon).

If you did something to change it from what it was like before in a certain plane, check your convergence settings.

<S>
"Curse your sudden (but inevitable!) betrayal!"
Grue

Offline FireDrgn

  • Silver Member
  • ****
  • Posts: 1115
Re: Lead computing gunsite problem?
« Reply #4 on: November 17, 2010, 08:48:20 PM »
It will show two if u have different caliber guns.   Like on the yak it has mugs and mm...
"When the student is ready the teacher will appear."   I am not a teacher.