B-26 Gunner Gunsights

[MachNix]

The gunsights for tail and top on the B-26 are flipped vertically.

Just in case I have to explain that, "flipped vertically" means upper-right in the gunsight file is lower-right when viewed from the gunner's position.

[Superfly]

Actually tail site is flipped horizontally.    I didn't see any problem with the top turret. Thanks.

[MachNix]

From my end both top and tail sights look flipped vertically, but I have been confused before.   

The images are: Test Gunsight; Top Gunsight; and Tail Gunsight.

[bustr]

I tested it and my results are the same as the OP's results.

I never would have noticed it using the standard AAF reticle for those gun positions though. The 3 Revi potions in the back seat of the Me410 do the same thing.

[Superfly]

All rear facing gun sights have this problem.  I remember it from when the Me 410 was released.  In the actual 3D model of the plane, the gun sights are correctly mapped to the polygon.  Not sure when/if this will be fixed.

[BluBerry]

 Not sure when/if this will be fixed.

So out of curiosity, why wouldn't you fix something that is obviously wrong, but spend time updating a clipboard that was fine in the first place..

[MachNix]

All rear facing gun sights have this problem.  I remember it from when the Me 410 was released.  In the actual 3D model of the plane, the gun sights are correctly mapped to the polygon.  Not sure when/if this will be fixed.

I know some other gunner gunsights had this same behavior and I just flip the gunsight file so it comes out correctly at the gunner's position.  The original 3D model for the B-26 was working correctly.  I only brought it up here because the 3D model is new and you may still be working out some bugs.  If there was something else that required going back into the 3D model, you might want to add the gunsights to the to-do list.