rudders not reading in game!

[oakranger]

I have a bit of a challenge with my rudders.  During the flight they were working then stop responding.  I thought maybe they got shot off, but nothing on damage.  I took off again and they still not reading.  Reboot the computer, nothing.  Re-calibrated, nothing.  Trying to figure out what is going on, i did everything i could possibly think of.  I could possibly think of.  In the map controllers on the clip broad, is reading the rudders movement, but not in the game.  Any suggestions?

[oakranger]

I just thought of something and test it out.  My rudders are not working on AHIII DX11 but they work on AHII.  SO.............

[Chalenge]

You might post this in the AHIII topic area.

[FLS]

Try renaming the settings folder and remapping your controls.

[Ack-Ack]

I just thought of something and test it out.  My rudders are not working on AHIII DX11 but they work on AHII.  SO.............

Have you checked the rudder axis mapping to make sure that the rudder axis was selected?  When I installed the pre-release and selected to import over my AH2 settings, I found that some of the settings didn't carry over like sound and controller mapping.  I had to reselect the axis on each controller in AH3.

[The Fugitive]

Make sure you set them up in the correct Mode as well.  If you have a mode switch button programmed to your stick you may have switched modes.