Author Topic: Force Feedback with MOZA AB9  (Read 62 times)

Offline streakeagle

  • Silver Member
  • ****
  • Posts: 1036
      • Streak Eagle - Stephen's Website
Force Feedback with MOZA AB9
« on: Yesterday at 09:16:12 PM »
When I use force feedback, the pitch axis centering force is inverted: as I move away from the center the force gets stronger in the direction I am moving. It is being repulsed from the center the further away I get from the center.

I have no problems in any other sims: DCS World, Il-2 Korea, Il-2 Forgotten Battles, etc.
I have the MOZA profile set to use only Direct Input and I am using a default profile with all of the MOZA options for centering, damping, etc. disabled.
I don't see any options in the MOZA software that could invert this force so that it pushes to the center.

The roll axis responds correctly: pushes back toward the center.
i5(4690K) MAXIMUS VII HERO(32 Gb RAM) GTX1080(8 Gb RAM) Win10 Home (64-bit)
OUR MISSION: PROTECT THE FORCE, GET THE PICTURES, ...AND KILL MIGS!

Offline hitech

  • Administrator
  • Administrator
  • *****
  • Posts: 12702
      • http://www.hitechcreations.com
Re: Force Feedback with MOZA AB9
« Reply #1 on: Today at 09:25:45 AM »
When I use force feedback, the pitch axis centering force is inverted: as I move away from the center the force gets stronger in the direction I am moving. It is being repulsed from the center the further away I get from the center.

I have no problems in any other sims: DCS World, Il-2 Korea, Il-2 Forgotten Battles, etc.
I have the MOZA profile set to use only Direct Input and I am using a default profile with all of the MOZA options for centering, damping, etc. disabled.
I don't see any options in the MOZA software that could invert this force so that it pushes to the center.

The roll axis responds correctly: pushes back toward the center.

I have not touched that system in years, is there any setup in your force feed back out side of aces high?

Also when flying level move the manual trim, what happens to the pitch force?

HiTech

HiTech

Offline streakeagle

  • Silver Member
  • ****
  • Posts: 1036
      • Streak Eagle - Stephen's Website
Re: Force Feedback with MOZA AB9
« Reply #2 on: Today at 03:56:20 PM »
There are tons of things to configure, but most of them are for adding forces/damping/etc. outside of the Direct Input signal.
The only axis inversion check box just reverses the response of the axis.
It is probably something to do with the way MOZA handles the Direct Input calls, but it works correctly with all my other flight sims.

The trim hat doesn't seem to do anything, but it is hard to say since the stick wants to go one way or the other as you get further away from the center.

I need to test the trim hat response with the roll axis, which has the correct centering force.

Guns and stall buffet are working well. I haven't been able to generate a high-speed buffet.

I have only tested the F4U-1A Corsair. I need to try other aircraft.
i5(4690K) MAXIMUS VII HERO(32 Gb RAM) GTX1080(8 Gb RAM) Win10 Home (64-bit)
OUR MISSION: PROTECT THE FORCE, GET THE PICTURES, ...AND KILL MIGS!