« previous next »
Pages: [1]   Go Down

Author Topic: Ram question  (Read 312 times)

Offline olddobe

  • Zinc Member
  • *
  • Posts: 58
      • http://n/a
Ram question
« on: January 23, 2002, 09:29:25 AM »
I have a new vid card otw,and now I find out that it's prolly gonna help in two ways,little and none.
Benchmarked system and cpu and vid card scored well.Ram and HD blew monkey chunks.HD is Maxtor 5400 rpm,and 512 megs of intermixed, piss poor ram,give terrible R/W scores.
I haven't looked yet,but wil on install of new vid card,wheter I have all micron ram.I'm not to up on ram so could use some help.Someone give me some ideas on how to remedy this situation please.
system Intel p3 1000 Mhz,I find out Trinty board only goes up to 750 Mhz???
512 megs ram!
tyan trinity 400 1854 MB
Via chip 133a I thinMaxtor 13 Gig HD 5400 rpm
Aus GTS 7700 Pure
SB live
Tried monkeying with Ram settings cas etc didnt help much got scared set bios back to stock.arrghh!

Dobe
Logged

Offline mrsid2

  • Parolee
  • Silver Member
  • ****
  • Posts: 1081
Ram question
« Reply #1 on: January 23, 2002, 09:32:28 AM »
You said your r/w score sucked. Compared to what? DDR / RDRAM?

You can bet your bottom dollar it will suck compared to those, simply because they're faster :)

However if youre getting unusually low mem scores and since you have a via board, I suggest you look out fresh drivers for the motherboard. VIA uses miniport drivers etc. which affect the performance a lot.

See at http://www.viahardware.com
Logged
Pages: [1]   Go Up
« previous next »