« previous next »
Pages: [1]   Go Down

Author Topic: Mother board problems  (Read 324 times)

Offline icemaw

  • Gold Member
  • *****
  • Posts: 2057
Mother board problems
« on: December 06, 2002, 11:54:43 AM »
Just installed a new ecs L7VTA mother board with usb2 port's. I cant get them to turn on. I go into setup and turn on usb ports but as system boots it gets to installing new usb hardware and the system hangs.  Anyone run across something like this?
Logged
Army of Das Muppets     
Member DFC Furballers INC. If you cant piss with big dogs go run with the pack

Offline eagl

  • Platinum Member
  • ******
  • Posts: 6769
Mother board problems
« Reply #1 on: December 06, 2002, 06:08:25 PM »
I had a problem like that when I tried to swap a VIA based motherboard in for an older intel motherboard.  Windows couldn't get it straight even after I removed every single hardware component from device manager, so it still tried to load intel drivers for the via hardware.

I had to do a complete windows install, since even doing a windows "upgrade" type install over the old installation failed in the same way.  I deleted the windows directory and started over.
Logged
Everyone I know, goes away, in the end.

Offline MOTJD

  • Zinc Member
  • *
  • Posts: 24
Once again
« Reply #2 on: December 06, 2002, 07:05:23 PM »
Try getting the latest 4 in 1 VIA drivers. That should cure the USB hangups.
Logged

Offline icemaw

  • Gold Member
  • *****
  • Posts: 2057
Mother board problems
« Reply #3 on: December 11, 2002, 05:29:46 PM »
Well I never could get the usb ports on the mother board to work. So I went out and bought a add on usb 2.0 card and guess what it worked no problems. So the ports on the board must be bad.
Logged
Army of Das Muppets     
Member DFC Furballers INC. If you cant piss with big dogs go run with the pack
Pages: [1]   Go Up
« previous next »