Aces High Bulletin Board

Help and Support Forums => Technical Support => Topic started by: lazydog on January 31, 2009, 01:51:07 PM

Title: x52 problems
Post by: lazydog on January 31, 2009, 01:51:07 PM

just wondering is it possible to use my throttle controls from the x52 with a different stick i was thinking of getting the ave8ter till i can get a ch stick?

Title: Re: x52 problems
Post by: The Fugitive on January 31, 2009, 11:21:34 PM

as long as the throttle only has the one USB plug and doesn't go through the stick, you should be ok.

Title: Re: x52 problems
Post by: potsNpans on February 01, 2009, 10:59:32 AM

I concur with Fugitive. Past X-52 stick went bad so I used X-52 throttle segment with an STP 290 stick.

Title: Re: x52 problems
Post by: Eagler on February 03, 2009, 07:17:59 AM

Quote from: The Fugitive on January 31, 2009, 11:21:34 PM

as long as the throttle only has the one USB plug and doesn't go through the stick, you should be ok.

?

you just put the jstick of the x52 hotas to the rear and program/use the other jstick while using the throttle from the x52.
this works fine when you use the stick programming inside AH.

Title: Re: x52 problems
Post by: The Fugitive on February 03, 2009, 08:03:31 AM

Quote from: Eagler on February 03, 2009, 07:17:59 AM

?

you just put the jstick of the x52 hotas to the rear and program/use the other jstick while using the throttle from the x52.
this works fine when you use the stick programming inside AH.

some throttle units connect to the stick also, so if you take the "partnering" stick out of the circuit, the throttle won't work.