« previous next »
Pages: [1]   Go Down

Author Topic: Saitek X-45 Throttle  (Read 319 times)

Offline Golfer

  • Platinum Member
  • ******
  • Posts: 6314
Saitek X-45 Throttle
« on: December 17, 2003, 05:36:28 PM »
Hey I know this should be in Hardware, but I hope skuzzy will cut me a break this once so I can get some views and assistance.

I'm looking for an X-45 throttle, just throttle.  If youve got one laying around that you cursed at for one reason or another I'd like to see about liberating it for you for a small fee.  My throttle snapped in half and is now laying, dead on the desk.  

Thanks!
Logged

Offline Estes

  • Gold Member
  • *****
  • Posts: 3647
Saitek X-45 Throttle
« Reply #1 on: December 17, 2003, 06:39:42 PM »
I have one I can give ya.. Shoot me an email. It's in the profile.
Logged

Offline Cobra412

  • Silver Member
  • ****
  • Posts: 1393
Saitek X-45 Throttle
« Reply #2 on: December 17, 2003, 07:23:33 PM »
Golfer did it snap just below the grip assembly itself on the main post area?  It looks like someone may be able to help you but if not got to a local sheet metal shop and have them build up  the outer cap piece on the throttle.  I gave my dad my last X45 for that same reason and he got some special cut sheet metal to fix it
Logged

Offline ALF

  • Silver Member
  • ****
  • Posts: 1208
      • http://www.mikethinks.com
Saitek X-45 Throttle
« Reply #3 on: December 17, 2003, 09:16:48 PM »
You could easily fab one out of wood, or even a good casting resin...after all...its not a high stress joint (or shouldnt be anyway:D )


If its the same as the X36 part...Ive got a few of those ;)
Logged
Pages: [1]   Go Up
« previous next »