Faber's 190 got tested untill it broke.
Would it not be normal to conclude that it's inital performance (untill it started giving trouble) would give a good account of a typical operable 190 performance at the time?
Or even above. The British removed the restrictions, in effect overboosting the engine.
The problem with the early tests of Faber's aircraft is that the British seem to have mixed up the engine settings they were using.
This, for example, is what the RAE reported for climb rate at 1.35 ata, 2450 rpm:

The RAE test is in purple. The A3 data comes from a chart Crumpp posted, the A5 I can't remember where I got the graph, but possibly Crumpp as well.
The RAE's data doesn't fit. Whilst they claim 2450 rpm, 1.35 ata, it seems to me the low gear figures (up to 8,000ft) are 1.35 ata, 2450 rpm, but the high gear figure (above 8000 ft) must be for 1.42 ata, 2700 rpm, yet the RAE specifically say 1.35 ata, 2450 rpm for both.
Personally, I take the initial tests of Faber's 190 with a pinch of salt, because I don't think it was tested at the settings the AFDU/RAE thought they were using. The later figures should be better, after they had a chance to get to know the aircraft.
I have copies of numerous allied reports on at least 5 different FW-190's. Some are derated and some are rated motors.
the Flugzueg-handbuch issues special instructions for rated motors as well.
Which A subtypes? AFAIK, derating was no longer standard from some time during A4 production. I believe the British also deliberately ignored some ratings to run the captured aircraft at settings they thought would be common in the future.