Anyone have a g940 profile they care to share for AH2 ?

[hlbly]

Looking for a place to start with profiling software . I started working on one and had a power outage  after a few hours work on one . . I am not sure I will use profiling software just would like a chance to try one and decide for myself .

[FLS]

PM me your address and I'll send you one.

[Kirin]

Got one too - quite simple but enough to work with. Includes buttons for TrackIR Center and Pause. Trim on rotaries.

[Skeksis]

How did you get the rotaries working for trim?

[FLS]

You just assign them in AH.

[Wagger]

Yea how did you get the trim rotaries to work in AH.  They don't seem to work for me.

[FLS]

I just assigned them the same way you assign the stick, throttle and rudder pedals. You don't do anything in the Profiler, just assign them in the AH controller setup.

[Skeksis]

I just assigned them the same way you assign the stick, throttle and rudder pedals. You don't do anything in the Profiler, just assign them in the AH controller setup.

I wonder what I am doing wrong then.  I tried assigning them and did not have much success with the attempt.  What I ended up with was one of them controlling elevator trim and the other controlling aileron trim but only in one direction so right now the trims are assigned to a hat.  Any suggestions how I got this messed up?

Thanks!

[hlbly]

Assign all button functions in profiler . Assign all analogue functions in Aces high .

[FLS]

I wonder what I am doing wrong then.  I tried assigning them and did not have much success with the attempt.  What I ended up with was one of them controlling elevator trim and the other controlling aileron trim but only in one direction so right now the trims are assigned to a hat.  Any suggestions how I got this messed up?

Thanks!

Calibrate the rotaries in windows, be sure they are centered for the center calibration, then calibrate them in AH. After you assign them in AH select the advanced tab and check the functioning.

[morfiend]

 I could be mistaken but if they are analog controls and you have combat trim set on by default you must first overide combat trim. You could toggle it off or turn it off in preferences,myself I use CT so I toggle it on or off and it must be off for my analog trim controls to work.


 Hope this helps!