Why are you trying to set a stick scale for the axis that is controlling your trim? You only need to calibrate the axis, don't set a stick scale for the trim axis, it's not needed at all and won't give any benefits.ack-ack
Because I find it hard to make fine adjustments to the trim around the center position. There's a detent in the center of that knob and it's damn near impossible to make a fine trim correction on either side of it without going further than you want. I figured if I scaled the input down around the center position it would allow me to make those corrections.
Tried what you said Skuzzy, no joy. I did use the deadband idea though to accomplish what I was trying to do. Still boggled about what is causing the scaled center to be off like that though.