
Recently, I have seen a 262 and a B-26 both crash on short final, both of which were operating on one engine, due to either flack or enemy gunfire! In both cases, the aircraft rolled over on their back and crashed, the player losing what ever damage points, and or kills recorded!
I realize that it wouldn't be practical to print the POH each aircraft in this game, but it would be very useful to know what the VMC is for each twin engine aircraft in the game. I realize a lot of things go into the computation of VMC for an aircraft, but I would suggest it be based on the following: Weight at 25% fuel, 59 degrees temperature, at sea level and 29.98 pressure!
The VMC should be included in the "E6B" on board the aircraft, when the player elects to display the E6B. I have done a few experiments flying different aircraft in here, in the "off line arena" just to satisfy myself where the safe operating minimum air speeds were on single engine operation! Below are some of speeds, if anyone is interest, that I use!
B-29, on two engines out on one side----130 IAS at 25% fuel and no bombs!
P-38L or J, on one engine, 105 IAS, nor ords and 25% fuel
B-25C or H-- 110 IAS
B-26B--- 110 IAS
C-47--- 95 IAS
If you are interested in testing for yourself, I would suggest the following procedure!
Climb out to 10,000 feet AGL, "cage" one engine, start a climb at full power on one engine and gradually increase the climb angle until you can no longer hold a constant heading with full rudder, and observe at what airspeed the aircraft started turning, which you can't stop with rudder and aileron and use that IAS as your VMC! When the aircraft "breaks", or stalls and you lose control, cut the operating engine to fully closed and lower the nose, then you will regain flying speed and control of the aircraft.
I realize there are a lot of people flying in here, who could care less what that value of VMC is, but if you lose a "perk" bird, and or kills and damage points because you didn't care what VMC was, then you will wish you knew what the minimum control airspeed is for single engine operation for that aircraft you are flying!