Author Topic: Bomber Sights  (Read 315 times)

Offline JJ

  • Zinc Member
  • *
  • Posts: 28
      • http://no
Bomber Sights
« on: July 09, 2002, 06:12:31 PM »
After Calerbration I go To Bomb Sight Screen Travels Left to Right Not Top to Bottom WHATS wrong Any ONE HELP PLZ????????????JPJ
Kiwi can Fly:)

Offline Flossy

  • Aces High CM Staff (Retired)
  • Plutonium Member
  • *******
  • Posts: 11070
      • Flossy's Website
Re: Bomber Sights
« Reply #1 on: July 09, 2002, 07:07:07 PM »
Quote
Originally posted by JJ
After Calerbration I go To Bomb Sight Screen Travels Left to Right Not Top to Bottom WHATS wrong Any ONE HELP PLZ????????????JPJ
Where abouts are you marking your point?  For best results, mark directly below the aircraft, which will give a better indication of your direction of travel and altitude - marking at a distance may be misleading...
Flossy {The Few}
Female Flying For Fun

Offline JJ

  • Zinc Member
  • *
  • Posts: 28
      • http://no
Bomber Sights
« Reply #2 on: July 09, 2002, 09:28:39 PM »
Thks Flossey I calerbrat Fine Its After I have Calber And go Back to Bomb Sight My trerain Dose not Travel Rhight When I look Down to Drop Bombs Ground is Traveling From RHight to Left Not
Top screen to Bottom any One Any HELP PLZ JPJ:confused:
:confused:
Kiwi can Fly:)

Offline airbull

  • Nickel Member
  • ***
  • Posts: 547
Bomber Sights
« Reply #3 on: July 10, 2002, 10:33:31 AM »
Did u press the key to come out of calibration mode.
If you can still move the cross about U didn t.
If u did, go out of bombsight then back in & retry calibration & see if its ok then.
'Crashed slow-rolling near ground. Bad show'

http://www.thefewsquadron.co.uk

Offline SKurj

  • Gold Member
  • *****
  • Posts: 3630
Bomber Sights
« Reply #4 on: July 10, 2002, 01:00:25 PM »
try calibrating again, and being sure to hold steady during the 'mark' process.

I've had this happen to me before as well, and usually going back in and recalibrating fixes it.  


SKurj