This is what I do in 190 to take off (hard to take off if messes up btw

)
1. turn engine on, full throttle, stick in full pull position, once right rudder (well, I am these without rudder pedals)
2. plane begins to roll, just little use of rudders (not too much because it reacts with little delay always) to keep it straight.
3. speed is above 80 IAS, I ease stick bit but still pulling slightly, do some little rudder changes, to keep it on runway after that.
4. speed is 100 IAS, I push nose to level.
5. 130-140 IAS, I gently pull up the plane and set rudders to default and activate auto angle for quick trims.
I do same in 109 also, but in it, I don't have to be such sharp after rudder and pulling the stick
(pulling the stick keeps tail gear on the ground which prevents plane from circeling around)